The PCB Assembly Process

In this article, you will learn about the PCB assembly process. This process is important in the manufacturing of printed circuit boards because of the high quality demands of consumers. Generally speaking, this process involves performing optimization strategies in order to make sure that there will be low levels of manufactured defects. In this way, consumers only get the best quality PCB.

There are a number of separate and distinct stages in the PCB assembly process. Nevertheless, it would be crucial for each stage to be performed correctly to be able to form a good overall printed circuit board.

In a nutshell, the process of assembling printed circuit boards involves the addition of solder paste to the place, pick and board of the component parts. In addition, it involves inspection, soldering and test. All these stages are important to make sure that the end product is of the highest quality possible.
PCB Board

The first step in the PCB assembly process is the addition of the solder paste.

The solder paste must be added in the board areas where solder will be needed. This is done through the use of a solder screen. Generally speaking, solder is required in areas such as component pads. Nevertheless, there will be other areas that will require solder so the paste must be added in them.

The second step in the process is the pick and place.

Once the solder paste had been added to the board, it is now time to execute the pick and place process. In the pick and place process, a reel loaded machine will technically place the board onto a correct position using the tension of the solder paste thereby adding the component parts.

The third step in the process is the soldering.

Once the component parts have been added through the pick and place process, the board will be passed through the soldering machine. There are two basic techniques of soldering machines that are widely used today: the first one is through a wave soldering machine and the second one is through reflow soldering strategies.

The fourth step in the process is inspection.

PCB AssemblyOnce the board has passed through the process of soldering, it is now time to inspect them. The purpose of the inspection is to detect this early if there are incorrectly placed components and joints, and incorrectly added components. In this way, there is a possibility that a defective printed circuit board be corrected the soonest possible time. In addition, should the boards of the same batch be of the same defects, the factory will be able to immediately correct them before too many boards are produced and the problem becomes unmanageable. There are two basic types of inspection: the first one is automatic inspection (optical) and the other is manual inspection.

The fifth step in the process is the testing.

Once the board passed the inspection stage, it will now be important to test it in electronic machines and products. In this way, the printed circuit board will not leave the factory’s premises without making sure that it will run satisfactorily for the consumer. There are certain ‘Test and Measurement’ techniques that are done by PCB manufacturers in order to make sure that their products are effective.

The sixth and final step in the PCB assembly process is the feedback.

Once the printed circuit board has left the factory’s premises, it will be important to make sure that the PCBs that were released are of the highest quality. How do they do this? They usually seek feedback from distributors, retailers and consumers. Some companies conduct frequent inspection of the printed circuit boards even after it left the factory.